7. On the right, remove plate [1] (x1).
8. With the fusing lamps still inside the hot roller, pull the leads [2] out of the rubber stoppers of the plate.
9. Carefully remove the fusing lamps from the hot roller.
• Use a dry cloth to avoid touching the lamps with your fingers. Oils from the fingers could cause
the lamp to burn unevenly.
• If you touch the surface of a fusing lamp accidentally, clean the surface with a clean cloth
dampened slightly with alcohol, then wipe it dry with a dry cloth.
Hot Roller
1. Remove:
• Fusing unit * p.345
Fusing
357
To Next Page
Loading...
