Source Event Type Width
233 <297
235
3rd Chg %
>611
[-5 to +5/00.01%]
236 461-610
237 298-460
238 <297
250 1st Change Speed Min. Length
This adjustment affects the minimum length of the paper fed from Tray 1 only when the roll feeder
is installed in Tray 2 as well.
[0 to 300/0/1 mm]
1919
Paper Interval Adjustment DFU
This SP allows you to increase or decrease the lengh of the interval between sheets when they
go through the paper feed path.
[0 to 1000/0/1 mm]
Notes:
• Enter the number with the operation panel, and push [#]. Use the [./*] key to enter a
minus sign.
• "0" is the smallest setting allowed. The "0" sets default interval of 90 mm; it does not set
the interval to zero.
• If this SP setting is less than the CPM down setting (which also sets the interval) the machine
will ignore this SP setting and use the CPM setting to set the interval between sheets.
• If this SP setting is more than the CPM down setting, the CPM setting will be subtracted
from this SP setting and the difference will be added to the CPM setting. For example, if
this SP setting "80" and CPM is "50", then (80 - 50) + 50 = 30 + 50 = 80 mm.
1920 Cut Length Adjustment
This SP adjusts the cut length for each paper source and type of paper.
SP1920 Settings Table
System Service Mode
97
To Next Page
Loading...
