10 5
11
Film
1
12 2
13 3
14 4
15 5
16 Plain: Low Temperature Mode [0 to 50/0/5 Steps]
1936 Lower Limit Temperature: Press Roller
This SP sets the minimum difference allowed between the actual temperature and the target
temperature of the pressure roller.
• If the setting for the target temperature of the pressure roller is high (SP1932), the
temperature of the pressure roller is lowered for continuous printing on plain paper.
• At this time, if the temperature is below the temperature set for the pressure roller, paper
feed will stop during a long job to perform inching to allow enough time for the pressure
roller temperature to rise to the level of the prescribed setting, and then the job will
continue.
Important:
• Modes "1" to "5" below refer to the paper and thickness settings selected in User Tools.
• In order for this SP to operate, SP9952-1 must be at "0" (default) so that the machine
can acquire temperature readings (feedback) from the pressure roller thermistors.
SP9952 should never be adjusted in the field.
Type Mode [Range/Default/Steps]
1
Plain
1
[0 to 50/20/5
o
C]
2 2
3 3
4 4
5 5
6
Trans.
1 [0 to 50/0/5
o
C]
7 2
[0 to 50/20/5
o
C]
8. Appendix: SP Mode Tables
108
To Next Page
Loading...
