1943
CPM Down Setting II DFU
The SP1940 settings control the operation of the CPM function while the machine is operating.
SP1943 controls the operation of the CPM down function after a cold start and after the
machine recovers from the energy save mode.
1 Enable II
This setting disables/enables the CPM down function after a cold start after the machine
recovers from the energy save mode.
[0 to 1/1/1]
Note: Disabling this feature is not recommended.
11 Paper Interval: Step 2 II [100 to 1500/450/10 mm]
12 Paper Interval: Step 3 II [100 to 1500/1300/10 mm]
SP1943-11, -12
Plain Paper, Recycled paper, Film
Mode 1 Mode 2 Mode 3 Mode 4 Mode 5
Step 1 160<T 155<T 148<T
Step 2 151<T<159 146<T<154 143<T<147
Step 3 T<150 T<145 T<142
Tracing Paper
Mode 1 Mode 2 Mode 3 Mode 4 Mode 5
Step 1 175<T 170<T 166<T 155<T
Step 2 166<T<174 161<T<169 156<T<165 146<T<154
Step 3 T<165 T<160 T<155 T<145
• The numbers in the table above are the temperatures at the center and end of the pressure roller
(measured by the pressure roller center and end thermistsor) when the machine is turned on or leaves
the energy save mode.
• The temperature thresholds are based on the type of paper selected for the job and the mode.
Range/Defaults for Both Types of Paper
8. Appendix: SP Mode Tables
112
To Next Page
Loading...
