Ricoh BE-C1 D046 - Page 572

• SP2401-5 controls current timing to areas other than the leading edge of cut sheet
paper.
[-30 to 30/19/1]
2402 Separation AC Current Adjustment
Adjusts the separation ac voltage setting. DFU
1 Roll Paper
[18 to 466/280/1 uA]
2 Cut Paper
2403
Separation DC Current Adjustment DFU
Adjusts the separation dc voltage. If the setting is too high, toner will be re-attracted from the
paper to the drum after transfer.
SP2403 Settings Table
Source Type Area [Range/Default/Step]
1
Roll
Plain
Leading Edge [0 to 80/40/0.1 uA]
2 Image Area [0 to 80/30/0.1 uA]
3
Trans
Leading Edge [0 to 80/50/0.1 uA]
4 Image Area
[0 to 80/40/0.1 uA]
5
Film
Leading Edge
6 Image Area [0 to 80/b/0.1 uA]
11
Cut
Plain
Leading Edge [0 to 80/60/0.1 uA]
12 Image Area [0 to 80/30/0.1 uA]
13
Trans
Leading Edge [0 to 80/0/60.1 uA]
14 Image Area
[0 to 80/0/40.1 uA]
15
Film
Leading Edge
16 Image Area [0 to 80/0/0.1 uA]
2602 PTL Adjustment DFU
8. Appendix: SP Mode Tables
124
8