5. Connect lower connector [A] (long harness) to the right connector, which was separated in the
previous step ( x1).
6. Connect lower connector [B] (short harness) to the left connector, which was separated in the previous
step ( x1).
7. Connect the harness from the lower drawer connector to the red connector [A] on the left side of the
machine ( x1).
8. Fasten the lower drawer connector ground [B] ( x1).
9. Push the connector right, left, up, and down to make sure there is a slight amount of play in the bracket
around the three screws.
2. Installation
56
To Next Page
Loading...
