214 Setting: Secondary Srv
215 Setting: Start Time
216 Setting: Interval Time
217 Setting: Timing
5849 Installation Date GW
Displays or prints the installation date of the machine.
1
Display
The "Counter Clear Day” has been changed to "Installation Date” or "Inst. Date”.
2
Switch to Print
Determines whether the installation date is printed on the printout for the total counter.
0: No Print
1: Print
3 Total Counter
Displays the total count on the day SP5849-1 was set.
5851
Bluetooth GW
Sets the operation mode for the Bluetooth Unit. Press either key.
[0: Public] / [1: Private]
5853 Stamp Data Download GW
Push [Execute] to download the fixed stamp data from the machine ROM onto the hard disk.
Then these stamps can be used by the system. If this is not done, the user will not have access
to the fixed stamps ("Confidential”, "Secret”, etc.).
You must always execute this SP after replacing the HDD or after formatting the HDD. Always
switch the machine off and on after executing this SP.
5856 Remote ROM Update DFU GW
When set to "1” allows reception of firmware data via the local port (IEEE 1284) during a
remote ROM update. This setting is reset to zero after the machine is cycled off and on. Allows
the technician to upgrade the firmware using a parallel cable
System Service Mode
193
To Next Page
Loading...
