7801 ROM No./Firmware Version
Displays the ROM version numbers of the main machine and connected peripheral devices.
7803 PM Counter Display GW
Displays the PM counter.
7804 PM Counter Reset GW
To clear the PM counter, press Start (SP7803).
7807 SC/Jam Counter Reset GW
Push [Start] to reset the SC and jam counters.
7826
MF Error Counter Japan Only GW
Displays the number of counts requested of the card/key counter.
1
Error Total
A request for the count total failed at power on. This error will occur if the device is installed
but disconnected.
2
Error Staple
The request for a staple count failed at power on. This error will occur if the device is installed
but disconnected.
7827
MF Error Counter Clear Japan Only GW
Press Execute to reset to 0 the values of SP7826. Japan Only
7832
Self-Diagnostic Report Details GW
Press # to display a list of error codes. Nothing is displayed if no errors have occurred.
7833 Toner Amount of Consumption Management DFU
Note: These SP codes are used for debugging by designers. For current display information,
refer to the Group 8000 SP codes referenced below.
System Service Mode
235
To Next Page
Loading...
