2
Back
Number of rear sides fed for scanning:
With an ADF that can scan both sides simultaneously, the Back count is the same as the
number of pages fed for duplex scanning.
With an ADF that cannot scan both sides simultaneously, the Back count is the same as
the number of pages fed for duplex rear-side scanning.
• When 1 sheet is fed for duplex scanning the Front count is 1 and the Back count is 1.
• If a jam occurs during the job, recovery processing is not counted to avoid double counting. Also, the
pages are not counted if the jam occurs before the first sheet is output.
8231 Scan PGS/Mode [0 to 9999999/1]
These SPs count the number of pages scanned by each ADF mode to determine the work
load on the ADF.
1 Large Volume
Selectable. Large copy jobs that cannot be loaded in the ADF
at one time.
2 SADF Selectable. Feeding pages one by one through the ADF.
3 Mixed Size Selectable. Select "Mixed Sizes” on the operation panel.
4 Custom Size Selectable. Originals of non-standard size.
5 Platen
Book mode. Raising the ADF and placing the original directly
on the platen.
6 Mixed 1side/2side Job mixed with printing one/two sides.
• If the scan mode is changed during the job, for example, if the user switches from ADF to Platen mode,
the count is done for the last selected mode.
• If the user selects "Mixed Sizes” for copying in the platen mode, the Mixed Size count is enabled.
• In the SADF mode if the user copies 1 page in platen mode and then copies 2 pages with SADF, the
Platen count is 1 and the SADF count is 3.
8241
T:Scan PGS/Org [0 to 9999999/1]
These SPs count the total number of scanned pages by original type for all jobs, regardless
of which application was used.
8242
C:Scan PGS/Org [0 to 9999999/1]
8. Appendix: SP Mode Tables
250
To Next Page
Loading...
