5120*
Mode Clear Opt. Counter
Removal
[0=Yes / 1=Standby only / 2=No]
5120 1
Specifies the condition to reset the copy job settings when the key counter is removed.
•
0: Y = Yes: The settings are cleared when the counter is removed.
• 1: StdBy = Standby only: The settings are cleared when the counter is removed at
the end of a job.
• 2: N = No: The settings are not cleared under either condition.
As for duplex copying, the job settings are always preserved regardless of these setting.
5121* Counter Up Timing [0 = Feed In / 1 = Exit]
5121 1
Selects the count-up timing.
•
0 = Feed: At each paper feed
• 1= Exit: At each paper exit
5127 APS Mode
001
[0: Not forbidden / 1: Forbidden]
Sets APS forbidden or not.
APS means “Auto paper size selection”.
5167
Fax Printing Mode at Optional Counter Off
Enables or disables the automatic print out without an accounting device. This SP is used
when the receiving fax is accounted by an external accounting device.
001 CTL
[ 0 or 1 / 0 / – ]
0: Automatic printing
1: No automatic printing
5169
CE Login
If you change the printer bit switches, you must 'log in' to service mode with this SP before
you go into the printer SP mode.
001 CE Login CTL
[0 or 1 / 0 / - ]
0: Disabled
1: Enabled
System Service Mode
57
To Next Page
Loading...
