Ricoh D127 - Page 298

049 Initialize All LDAP Addr Book
Clears the LDAP address book information, except the
user code.
050 Initialize All Addr Book
Clears all directory information managed by UCS,
including all user codes.
Turn the main power switch off and on after executing
this SP.
051 Backup All Addr Book Uploads all directory information to the SD card.
052 Restore All Addr Book Downloads all directory information from the SD card.
053 Clear Backup Info
Deletes the address book data from the SD card in the
service slot.
Deletes only the files that were uploaded from this
machine.
This feature does not work if the card is write-protected.
Note: After you do this SP, go out of the SP mode, and
then turn the power off. Do not remove the SD card until
the Power LED stops flashing.
060 Search Option
This SP uses bit switches to set up the fuzzy search
options for the UCS local address book.
Bit0: Checks both upper/lower case characters
Bit1: Japan only
Bit2 to 7: Not used
062 Complexity Option 1
(1)
Use this SP to set the conditions for password entry to
access the local address book. Specifically, this SP
limits the password entry to upper case and sets the
length of the password.
[0 to 32 / 0 / 1 /step]
063 Complexity Option 2
(1)
Use this SP to set the conditions for password entry to
access the local address book. Specifically, this SP
limits the password entry to lower case and defines the
length of the password.
[0 to 32 / 0 / 1 /step]
3. Appendix: SP Mode Tables
90