Code Meaning Suggested Cause/Action
0-05
Modem training fails even G3
shifts down to 2400 bps.
• Check the line connection.
•
Try adjusting the tx level and/or cable equalizer.
• Replace the FCU.
• Check for line problems.
Cross reference
See error code 0-04.
0-06
The other terminal did not
reply to DCS
• Check the line connection.
•
Try adjusting the tx level and/or cable equalizer
settings.
• Replace the NCU or FCU.
• The other end may be defective or incompatible; try
sending to another machine.
• Check for line problems.
Cross reference
See error code 0-04.
0-07
No post-message response
from the other end after a
page was sent
• Check the line connection.
• Replace the NCU or FCU.
• The other end may have jammed or run out of paper.
• The other end user may have disconnected the call.
• Check for a bad line.
• The other end may be defective; try sending to
another machine.
4. Appendix: Fax Troubleshooting Guide
160
To Next Page
Loading...
