No FUNCTION COMMENTS
0
TTI printing position
0: Superimposed on the page
data
1: Printed before the data leading
edge
Change this bit to 1 if the TTI overprints information that
the customer considers to be important (G3
transmissions).
1-2 Not used Japan Only
3
TTI used for broadcasting
0: The TTIs selected for each
Quick/Speed dial are used
1: The same TTI is used for all
destinations
1: The TTI (TTI_1 or TTI_2) which is selected for all
destinations during broadcasting.
*TTI= Transmit Terminal Identification
4-7 Not used Do not change the factory settings.
System Switch 12 [SP No. 1-101-019]
No FUNCTION COMMENTS
0-7
TTI printing position in the main
scan direction
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for the TTI
from the left edge of the paper. If the TTI is moved too far
to the right, it may overwrite the file number which is on
the top right of the page. On an A4 page, if the TTI is
moved over by more than 50 mm, it may overwrite the
page number.
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
System Switch 15 [SP No. 1-101-022]
No FUNCTION COMMENTS
0 Not used Do not change the settings.
5. Appendix: Fax Service Program
200
To Next Page
Loading...
