0-5 Not used Do not change the settings.
6
Scanner page-memory
expansion (On DRAM added)
0: Not expanding
1: Expanding
Expands the 4MB page-memory to 12MB, to improve
scanning possible range.
This SW does not work without DRAM added.
7
Special Original mode
0: OFF
1: ON
1: If the customer frequently wishes to transmit a form or
letterhead which has a colored or printed background,
change this bit to “1”. “Original 1” and “Original 2” can
be selected in addition to the “Text”, “Text/Photo” and
“Photo” modes.
System Switch 1A [SP No. 1-101-027]
No FUNCTION COMMENTS
0-7
LS Rx Memory threshold value
setting
[00 – FF: HEX
(0 – 1020 k Byte)]
Default: 0x80(512k Byte)
The received document is printed automatically after the
memory remaining amount becomes less than or equal to
this Switch’s value.
Changing hex-value to decimal and then multiplying the
value by 4, suggests xxx K byte.
[i.e.: 80 changes to 128 in hex to decimal conversion.
128x4= 512K Byte]
System Switch 1B - Not used (do not change these settings)
System Switch 1C - Not used (do not change these settings)
System Switch 1D [SP No. 1-101-030]
No FUNCTION COMMENTS
0
RTI/CSI/CPS code display
0: Enable
1: Disable
0: RTI, CSI, CPS codes are displayed on the top line of the
LCD panel during communication.
1: Codes are switched off (no display)
1-7 Not used Do not change these settings.
System Switch 1E [SP No. 1-101-031]
5. Appendix: Fax Service Program
202
To Next Page
Loading...
