No FUNCTION COMMENTS
0 Not used Do not change the settings.
1
Report printout after an original
jam during SAF storage or if the
SAF memory fills up
0: Enabled
1: Disabled
0: When an original jams, or the SAF memory overflows
during scanning, a report will be printed.
Change this bit to “1” if the customer does not want to
have a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
2 Not used Do not change the settings.
3
Received fax print start timing
(G3 reception)
0: After receiving each page
1: After receiving all pages
0: The machine prints each page immediately after the
machine receives it.
1: The machine prints the complete message after the
machine receives all the pages in the memory.
4-6 Not used Do not change the factory settings.
7
Action when a fax SC has
occurred
0: Automatic reset
1: Fax unit stops
0: When the fax unit detects a fax SC code other than
SC1201 and SC1207, the fax unit automatically resets
itself.
1: When the fax unit detects any fax SC code, the fax unit
stops.
Cross Reference
Fax SC codes - See “Troubleshooting”
I-Fax Switches
I-fax Switch 00 [SP No. 1-102-001]
No
FUNCTION COMMENTS
Original size limitation of TX
Attachment File
These settings set the size applying to adjusting the
transmitted original data so that the destination can
receive within its capacity.
5. Appendix: Fax Service Program
204
To Next Page
Loading...
