Ricoh D127 - Page 318

System Service Mode
D127/D128 3-62 SM Appendix
006
DHCP (Ethernet /
IEEE802.11)
Determines whether DHCP IP Address Setting is
used or not.
[0: Not used 1: Used]
021 Active IPv4 Address Default: 00000000 H (000.000.000.000)
022 Active IPv4 Subnet Mask Default: 00000000 H (000.000.000.000)
023
Active IPv4 Gateway
Address
Default: 00000000 H (000.000.000.000)
050
1284 Compatibility
(Centro)
[0:Not permitted 1:Permitted]
052 ECP (Centro) [0:Not permitted 1:Permitted]
065 Job Spooling
Enables/disables Job Spooling.
[0 or 1 / 0 / 1 /step]
0: Disable, 1: Enable
066
Job Spooling clear: start
time
Determines whether spooled job in the HDD is
cleared or printed on machine start-up.
[0: Clear 1: Print]
069 Job Spooling (Protocol)
Validates or invalidates the job spooling function
for each protocol.
0: Validates
1: Invalidates
bit0: LPR
bit1: FTP
bit2: IPP
bit3: SMB
bit4: BMLinkS
bit5: DIPRINT
bit6: (Reserved)
bit7: (Reserved)