Ricoh D129 - Page 1042

Error Codes
D629 24 SM
Code Meaning Suggested Cause/Action
0-30 The other terminal did not
reply to NSS(A) in AI short
protocol mode
 Check the line connection.
 Try adjusting the tx level and/or cable
equalizer settings.
 The other terminal may not be compatible.
Cross reference
Dedicated tx parameters - Section 4
0-32 The other terminal sent a
DCS, which contained
functions that the receiving
machine cannot handle.
 Check the protocol dump list.
 Ask the other party to contact the
manufacturer.
0-33 The data reception (not ECM)
is not completed within 10
minutes.
 Check the line connection.
 The other terminal may have a defective
modem/FCU.
0-52 Polarity changed during
communication
 Check the line connection.
Retry communication.
0-55 FCU does not detect the SG3.  FCU firmware or board defective.
 SG3 firmware or board defective.
0-56 The stored message data
exceeds the capacity of the
mailbox in the SG3.
SG3 firmware or board defective.
0-70 The communication mode
specified in CM/JM was not
available
(V.8 calling and called
terminal)
 The other terminal did not have a
compatible communication mode (e.g., the
other terminal was a V.34 data modem and
not a fax modem.)
 A polling tx file was not ready at the other
terminal when polling rx was initiated from
the calling terminal.
0-74 The calling terminal fell back
to T.30 mode, because it
could not detect ANSam after
sending CI.
 The calling terminal could not detect
ANSam due to noise, etc.
 ANSam was too short to detect.
 Check the line connection and condition.
 Try making a call to another V.8/V.34 fax.