Ricoh D129 - Page 1043

Error Codes
SM 25 D629
Fax Option
Type 5002
(D629)
Code Meaning Suggested Cause/Action
0-75
The called terminal fell back to
T.30 mode, because it could
not detect a CM in response
to ANSam (ANSam timeout).
 The terminal could not detect ANSam.
 Check the line connection and condition.
 Try receiving a call from another V.8/V.34
fax.
0-76 The calling terminal fell back
to T.30 mode, because it
could not detect a JM in
response to CM
(CM timeout).
 The called terminal could not detect a CM
due to noise, etc.
 Check the line connection and condition.
 Try making a call to another V.8/V.34 fax.
0-77
The called terminal fell back to
T.30 mode, because it could
not detect a CJ in response to
JM
(JM timeout).
 The calling terminal could not detect a JM
due to noise, etc.
 A network that has narrow bandwidth
cannot pass JM to the other end.
 Check the line connection and condition.
 Try receiving a call from another V.8/V.34
fax.
0-79 The called terminal detected
CI while waiting for a V.21
signal.
 Check for line noise or other line problems.
 If this error occurs, the called terminal falls
back to T.30 mode.
0-80 The line was disconnected
due to a timeout in V.34 phase
2 – line probing.
 The guard timer expired while starting
these phases. Serious noise, narrow
bandwidth, or low signal level can cause
these errors.
If these errors happen at the transmitting
terminal:
 Try making a call at a later time.
 Try using V.17 or a slower modem using
dedicated tx parameters.
 Try increasing the tx level.
 Try adjusting the tx cable equalizer setting.
0-81 The line was disconnected
due to a timeout in V.34 phase
3 – equalizer training.
0-82 The line was disconnected
due to a timeout in the V.34
phase 4 – control channel
start-up.