Ricoh D129 - Page 1048

Error Codes
D629 30 SM
Code Meaning Suggested Cause/Action
6-99 V.21 signal not stopped within
6 s
Replace the FCU.
13-17 SIP user name registration
error
 Double registration of the SIP user name.
 Capacity for user-name registration in the
SIP server is not sufficient.
13-18 SIP server access error  Incorrect initial setting for the SIP server.
 Defective SIP server.
13-24 SIP authentication error  Registered password in the device does
not match the password in the SIP server.
13-25 Network I/F setting error  IPV4 is not active in the active protocol
setting.
 IP address of the device is not registered.
13-26 Network I/F setting error at
power on
 Active protocol setting does not match the
I/F setting for SIP server.
 IP address of the device is not registered.
13-27 IP address setting error  IP address of the device is not registered.
14-00 SMTP Send Error 
Error occurred during sending to the SMTP
server. Occurs for any error other than
14-
01 to 16. For example, the mail address
of the system administrator is not
registered.
14-01 SMTP Connection Failed  Failed to connect to the SMTP server
(timeout) because the server could not be
found.
 The PC is not ready to transfer files.
 SMTP server not functioning correctly.
 The DNS IP address is not registered.
 Network not operating correctly.
 Destination folder selection not correct.