SM 119 D619
1
Action when the SAF memory
has become full during
scanning
0: The current page is erased.
1: The entire file is erased.
0: If the SAF memory becomes full during
scanning for a memory transmission, the
successfully scanned pages are transmitted.
1: If the SAF memory becomes full during
scanning for a memory transmission, the file is
erased and no pages are transmitted.
Note: This setting is effective only when
Automatic Journal printout is enabled but the
machine cannot print the report (e.g., no
paper).
2
RTI/CSI display priority
0: RTI 1: CSI
This bit determines which identifier, RTI or CSI,
is displayed on the LCD while the machine is
communicating in G3 non-standard mode.
3
File No. printing
0: Enabled
1: Disabled
1: File numbers are not printed on any reports.
Note: The file numbers may not be printed in
the sequential order. If a customer does not like
this numbering, select "0".
4
Action when authorized
reception is enabled but
authorized RTIs/CSIs are not
yet programmed
0: Faxes can be received if the
sender has an RTI or CSI
1: All fax reception is disabled
0: If the user has stored no acceptable sender
RTIs or CSIs, the user can select “ON” in the
authorized reception setting but the setting
becomes invalid (“OFF”). The machine will not
be able to receive any fax messages. If the
customer wishes to receive messages from
any sender that includes an RTI or CSI, and to
block messages from senders that do not
include an RTI or CSI, change this bit to "0",
then enable Authorized Reception.
Otherwise, keep this bit at "1 (default setting)".
5-7 Not used Do not change the settings
To Next Page
Loading...
