Ricoh D131 - Page 496

SC500: Feed, Transport, Duplex, and Fusing
SM Appendix 2-29 D131/D132/D133
Appendix:
Service Call
Conditions
SC515-00 C
Duplex jogger motor error 1
When the jogger fence moves to the home position, the jogger HP
sensor does not turn on even if the jogger fence motor has moved
the jogger fence 153.5 mm.
 Paper or other obstacle has jammed mechanism
 Sensor connector disconnected or defective
 Sensor defective
SC516-00 C
Duplex jogger motor error 2
When the jogger fence moves from the home position, the jogger
fence HP sensor does not turn off even if the jogger motor has
moved the jogger fence 153.5 mm.
 Paper or other obstacle has jammed mechanism
 Sensor connector disconnected or defective
 Sensor defective
SC530-00 D
Main fan error
The main fan motor lock signal goes high for 5 s while the fan is on.
 Fan motor overloaded due to obstruction
 Fan connector disconnected
SC540-01 D
Fusing exit motor error
The PLL lock signal was low for 2 s during motor operation.
 Motor lock caused by physical overload
 Motor drive PCB defective