Ricoh D131 - Page 521

SC700: Peripherals
D131/D132/D133 2-54 SM Appendix
SC720-87 D
Finisher punch motor error (D611/D612)
The punch HP sensor is not activated within the specified time
after the punch motor turned on. The 1st detection failure issues a
jam error, and the 2nd failure issues this SC code.
 Punch HP sensor disconnected, defective
 Punch motor disconnected, defective
 Punch motor overload due to obstruction
SC722-01 D
Downstream finisher communication error
No response signal was received from the downstream finisher
(D610) after 3 attempts
 Finisher I/F cable loose, broken defective
 Finisher control board defective
SC722-10 B
Transport motor error (D610)
A pulse signal from the transport motor could not be detected within
the prescribed time. The first detection triggers a jam code, and the
second detection triggers this SC.
 Motor overload due to an obstruction
 Motor harness connector loose, broken, defective
 Motor defective
SC722-24 B
Exit guide motor (D610)
The status of the exit guide sensor did not change at the
prescribed time during operation of the exit guide.
 Exit guide open sensor loose, broken, defective.
 Exit guide motor defective
 Finisher main board defective