Ricoh D131 - Page 530

SC700: Peripherals
SM Appendix 2-63 D131/D132/D133
Appendix:
Service Call
Conditions
SC725-12 B
Reg. Roller Transport Motor Error Multi Folder (D615)
The motor drive PCB detected an error at the motor.
 Motor harness or connector loose, broken, defective
 Motor or motor drive board defective
SC725-13 B
Dynamic Roller Transport Motor Error Multi Folder (D615)
The motor drive PCB detected an error at the motor.
 Motor harness or connector loose, broken, defective
 Motor or motor drive board defective
SC725-14 B
Z-fold top tray exit motor error
The motor driver detects an error.
 Motor over current
 Motor driver overheat
SC725-30 B
Z-fold stopper 1 Motor error
The bottom fence HP sensor detected that:
The bottom fence did not arrive at the home position at the
specified time.
-or-
The bottom fence failed to leave the home position at the specified
time.
 Motor over-current
 Motor driver overheat
 Motor harness loose