Ricoh D131 - Page 548

SC800: Overall System
SM Appendix 2-81 D131/D132/D133
Appendix:
Service Call
Conditions
SC860 B
HDD startup error at power on GW
HDD is connected but a driver error is detected. The driver did not
respond with the status of the HDD within 30 sec.
 HDD is not initialized
 Level data is corrupted
 Initialize the HDD with SP5-832-001.
 HDD is defective
SC861 B
HDD Error 2: HDD Startup GW
The hard disks were detected at power on, but the disks were not
detected within 30s after recovery from the energy conservation mode.
 Cable between the hard disks and controller board disconnected
or loose
 Hard disk power connector loose
 One of the hard disks is defective
 Controller defective
SC862 D
Bad sector overflow GW
There more 100 bad sectors in image storage area of the HDD.
 Format HDD with SP4911-2
 HDD defective