Service Call 501-584
D146/D147/D148/D149/D150 5-48 SM
SC No. Level Error Name/Error Condition/Major Cause/Solution
§ Reset the paper
§ Remove the foreign matter
§ Replace the motor
§ Reset the connector
§ Replace the harness
§ Replace the sensor
§ Replace the control board for the optional paper feed tray
§ Replace the tray
§ Replace the paper feed roller
§ Replace the pick-up arm
§ Replace the timing belt
§ Replace the timing pulley
§ Replace the base plate
SC503-32 B 3rd Tray Lowering Error (LCIT)
§ Lower limit detection error (during descent)
During tray initialization (upper limit not detected/lower eject
limit detection), the tray base plate is lowered to check the
tray base plate position, and the lower limit sensor is not
detected although a predetermined time elapsed.
Alternatively, at paper end, the tray base plate is lowered,
but the lower limit sensor is not detected although a
predetermined time elapsed.
§ Lower limit error (during ascent)
During tray initialization (upper limit eject detection/lower
limit detection), the tray base plate is raised to check the
tray base plate position, and the lower limit sensor is
detected although a predetermined time elapsed.
*If an error occurs 3 times consecutively: LCIT transmits
"3rd tray lower limit detection error" to the main machine. Up
to 2 times consecutively, LCIT transmits "tray set fault" to
the main machine.
To Next Page
Loading...
