Service Call 501-584
SM 5-49 D146/D147/D148/D149/D150
SC No. Level Error Name/Error Condition/Major Cause/Solution
§ Lift motor error/connector missing
§ Lower limit sensor error/connector missing
§ Harness broken
§ Bank control board defective
§ Foreign matter, such as paper scrap, is caught between the
right tray and the tray lift motor
§ Paper set fault
§ Timing belt damage/dropout
§ Timing pulley damage/dropout
§ Base plate damage/horizontality fault
§ Foreign matter, such as paper scrap, is caught inside the
right tray
§ Reset the paper
§ Remove the foreign matter
§ Replace the motor
§ Reset the connector
§ Replace the harness
§ Replace the sensor
§ Replace the control board for the optional paper feed tray
§ Replace the tray
§ Replace the timing belt
§ Replace the timing pulley
§ Replace the base plate
SC503-33 B 3rd Tray Paper Overload Error (LCIT)
During tray initialization, both the upper limit and lower limit are
detected 3 times consecutively.
(up to 2 times consecutively, LCIT transmits "tray set fault" to the
main machine)
To Next Page
Loading...
