Service Call 501-584
D146/D147/D148/D149/D150 5-50 SM
SC No. Level Error Name/Error Condition/Major Cause/Solution
§ Paper overload
§ Paper set fault
§ Limit sensor error/connector missing
§ Lower limit sensor error/connector missing
§ Harness broken
§ Bank control board defective
§ Foreign matter, such as paper scrap, is caught inside the
right tray
§ Reset the paper
§ Remove the foreign matter
§ Reset the connector
§ Replace the harness
§ Replace the sensor
§ Replace the control board for the optional paper feed tray
SC503-34 B 3rd Tray Paper Position Error (LCIT)
During left/right tray set, or when power is switched ON, or when
transfer is complete, "open" is detected 3 times consecutively by
end fence open/close detection.
(up to 2 times consecutively, LCIT transmits "tray set fault" to the
main machine)
§ Paper set fault (paper is offset from position for pushing end
fence)
§ Foreign matter entry (foreign matter is caught in the position
for pushing end fence)
§ End fence open/close sensor error/connector missing
§ Harness broken
§ Bank control board defective
§ Reset the paper
§ Remove the foreign matter
§ Reset the connector
§ Replace the harness
§ Replace the sensor
§ Replace the control board for the optional paper feed tray
To Next Page
Loading...
