Ricoh D158 - Page 880

Error Codes
D702 38 SM
Code Meaning Suggested Cause/Action
22-01 Memory overflow while
receiving
 Wait for the files in the queue to be sent.
 Delete unnecessary files from memory.
 Transfer the substitute reception files to
an another fax machine, if the machine’s
printer is busy or out of order.
 Add an optional SAF memory card or hard
disk.
22-02 Tx or rx job stalled due to line
disconnection at the other
end
 The job started normally but did not finish
normally; data may or may not have been
received fully.
 Restart the machine.
22-03 The hard disk for cache is full
during fax reception.
 Replace the HDD.
 Replace the FCU.
22-04 The machine cannot store
received data in the SAF
 Update the ROM
 Replace the FCU.
22-05 No G3 parameter
confirmation answer
 Defective FCU board or firmware.
23-00 Data read timeout during
construction
 Restart the machine.
 Replace the FCU.
25-00 The machine software resets
itself after a fatal transmission
error occurred
 Update the ROM
 Replace the FCU.
31-00 Remote printer capacity
(transfer mode) not matching
 The other terminal is incompatible.
 Capability mismatch
31-01 Remote printer capacity
(compression format) not
matching
31-02 Remote printer capacity
(page memory capacity) not
matching
31-03 Remote printer capacity
(resolution) not matching
31-04 Remote printer capacity
(paper size) not matching
31-05 Remote printer capacity
(emulation) not matching