5
Control Panel
This illustration shows the control panel of a machine with options
fully installed.
1.
Screen Contrast knob
Adjusts the brightness of the display pan-
el.
2.
Indicators
These indicators show the status of the
machine or indicate errors. See “Control
Panel”, General Settings Guide.
3.
{
{{
{User Tools/Counter}
}}
} key
• User Tools
Press to change the default settings
and conditions to meet your require-
ments. See p.115 “User Tools (Copi-
er/Document Server Features)”.
• Counter
Press to check or print the Counter
value. See “Counter”, General Settings
Guide.
• Inquiry
Shows where to order expendable
supplies and where to call when a
malfunction occurs. You can also print
these details. See “Inquiry”, General
Settings Guide.
4.
Display panel
Shows operation status, error messages,
and function menus. See “Display Pan-
el”, General Settings Guide.
5.
{
{{
{Check Modes}
}}
} key
Press to check the entered copy job set-
tings.
6.
{
{{
{Program}
}}
} key
Press to store or recall a program. See
p.81 “Programs”.
7.
{
{{
{Clear Modes}
}}
} key
Press to clear previously entered copy job
settings.
8.
{
{{
{Energy Saver}
}}
} key
Press to switch to and from Energy Saver
mode. See “Saving Energy”, General Set-
tings Guide.
9.
{
{{
{Interrupt}
}}
} key
Press to interrupt a long copy job to make
copies. See p.20 “Interrupt Copy”.
10.
Main power indicator, On indi-
cator
The main power indicator goes on when
the main power switch is turned on and
goes off when the switch is turned off.
The On indicator goes on when the oper-
ation switch is turned on and goes off
when the switch is turned off.
Important
❒ Do not turn the main power off
while the On indicator is flashing.
The hard disk may malfunction.
ZGVS300N
MartiniC2_EN_Copy-F1_FM.book Page 5 Tuesday, July 27, 2004 1:43 PM
To Next Page
Loading...
