Printing with the Finisher
91
4
Note
❒ Punch positions will vary slightly from page to page as holes are punched
into each sheet individually.
Reference
For information about paper sizes that can be punched, see “Specifications”,
General Settings Guide.
For printing methods, see the printer driver Help.
The punch position will vary when using the PostScript 3 printer driver. For
details, see the PostScript 3 printer driver Help.
Punching Precautions
Limitation
❒ Punching cannot be done when paper is fed from the bypass tray.
Note
❒ If you cannot make punch settings even with the finisher installed, options
may not be set correctly in the printer driver. Correct option settings in the
printer driver. For details, see the printer driver Help.
❒ When duplex printing is selected, adjust punch positions according to bind-
ing orientation.
❒ Be sure to set the punch position the same as the staple position when using
it with the staple function.
❒ Be sure to set paper size and orientation in the printer driver when punching.
• Depending on the software you are using, print settings may not be ena-
bled and the printed result may not be as expected.
❒ Punch will be canceled under the following conditions:
• When a paper size that cannot be punched is selected. For information
about paper sizes that can be punched, see “Specifications”, General Set-
tings Guide.
• If positions other than those fixed for punching are specified.
• If there are inconsistencies between the orientation in duplex mode and the
punch position.
• When feeding paper from the bypass tray.
• When the punch receptacle has become full and Auto Continue is set,
printing will continue without punching after the message appears.
MartiniC25-EN-Pref-F_FM_ZF.book Page 91 Tuesday, July 27, 2004 11:51 AM
To Next Page
Loading...
