Settings You Can Change with User Tools
59
4
Note
❒ Default:
• Paper Type: No Display
• Copying Method: 2 Sided Copy
• Apply Auto Paper Select: Yes
❒ A mark is displayed next to the paper tray if “No” is selected.
❒ The optional tab sheet holder is required when using tab stock in tray 2 or
3.
❒ The number of tab stock shifts can be set in millimeters, when [Tab Stock]
has been selected.
❒ The number of tab stock shift can be set in 1 millimeter (1 inch) units, with-
in a range of 0 to 15 mm(0" to 0.6"). The default is 13 mm(0.5").
❒ “Thick Paper” and “Tab Stock” can be set simultaneously.
Limitation
❒
[Auto Paper Select] can only be selected for the copier function if [No Display]
and [Recycled Paper] are selected. If [No] is selected, Auto Paper Select is not
valid.
❖
❖❖
❖ Cover Sheet Tray
You can specify and display the paper tray that is used to set cover sheets. Af-
ter selecting the paper tray, you can also specify the display timing and copy
method for two-sided copying.
Note
❒ Default:
• Tray to Program: Off
❒ Functions using the Cover Sheet Tray setting are front cover function and
front/back cover function.
❒ When [At Mode Selected] is selected, the cover sheet tray settings are only
displayed when the cover function or slip sheet function is selected.
❒ You can set Copying Method in Duplex setting only when [At Mode Select-
ed] is selected.
Reference
“Covers”, Copy Reference
❖
❖❖
❖ Slip Sheet Tray, Designation Sheet Tray 1/2
You can specify and display the paper tray that is used for setting slip sheets.
You can also specify the display timing and copy method for two-sided copy-
ing.
Note
❒ Default:
• Tray to Program: Off
MartiniC2_ENzen_F_pre_FM.book Page 59 Tuesday, July 27, 2004 1:24 PM
To Next Page
Loading...
