30 November, 1999 ERROR CODES
7-31
Trouble-
shooting
Code Meaning Suggested Cause/Action
1-10
Paper at the scan line
when the power was
turned on.
Remove the document.
Check the scan line sensor.
Cross-reference
ADF mechanical problems - Section 7-2-1
1-17 Document jam in the feed-
out area
Clear any debris from the sensor actuator.
Check the ADF drive components and sensors.
Cross-reference
ADF mechanical problems - Section 7-2-1
1-20 Paper did not reach the
fusing exit at the end of
printing
Remove the paper.
Check the printer drive components and
sensors.
Cross-reference
Printer mechanical problems - Section 7-2-2
1-21
Paper present at the fusing
exit after printing
Remove the paper.
Check the printer drive components and
sensors.
Cross-reference
Printer mechanical problems - Section 7-2-2
1-30 Paper ran out during
printing
Add paper in the cassette.
1-34 Paper ran out after printing Add paper in the cassette.
1-71
The cover was opened or
the cassette was pulled out
during printing
Close the cover or put back the cassette.
2-10
The modem cannot enter
TX mode
Replace the FCU.
2-11 Only one V.21 connection
flag was received
Change the FCU.
2-12 Modem clock irregularity Replace the FCU.
2-20 Abnormal coding/decoding
(CPU not ready)
Replace the FCU.
2-50 The machine reset itself Replace the FCU.
4-10
Communication failed
because of Tel. No./CSI
mismatch (Protection
against Wrong
Connections)
Reprogram the CSIs correctly, then re-send.
The machine at the other end may be defective.
5-00 Data reconstruction not
possible
Replace the FCU.
5-10 DCR timer expired Replace the FCU.
5-20
Storage impossible
because of a lack of
memory
5-21 Memory overflow
Temporary memory shortage.
Replace the FCU or optional IC card.
5-22
Mode table overflow after
the second page of a
scanned document
Wait for the messages that are currently in the
memory to be sent, or delete some files from
memory.
To Next Page
Loading...
