Ricoh FAX2000L - Page 84

30 November, 1999 BIT SWITCHES
4-17
Service
Tables
System Switch 05
No FUNCTION COMMENTS
0-1
Not used Do not change these settings.
2 Display of both RTI and CSI
on the LCD
0: Disabled 1: Enabled
1: Both RTI and CSI will be displayed alternately
on the LCD.
3-7
Not used Do not change these settings.
System Switch 06
No FUNCTION COMMENTS
0 Use of the Stop key during
memory transmission
0: Disabled 1: Enabled
1: The Stop key can be used to halt memory
transmissions. However, users might
accidentally cancel another person's memory
transmission in progress.
1-3
Not used Do not change these settings.
4
Use of the Stop key during
memory transmission
0: Disabled 1: Enabled
1: The Stop key can be used to halt memory
transmissions. After pressing the Stop key, a
message (STOP & CLR FILE?) appears on the
LCD.
5-7
Not used Do not change these settings.
System Switch 07 - Not used (do not change any of these settings)
System Switch 08 - Not used (do not change any of these settings)
System Switch 09
No FUNCTION COMMENTS
0
Not used Do not change this setting.
1
Inclusion of communications in
the Journal when no image
data was exchanged.
0: Disabled 1: Enabled
0: The Journal lists communications that
reached phase C (message TX/RX) of the T.30
protocol.
1: The Journal lists communications that
reached phase A (call setup) of T.30 protocol.
This includes telephone calls.
2 Automatic error report printout
0: Disabled 1: Enabled
0: Error reports are not printed.
1: Error reports will print automatically after all
failed communications, excluding polling
reception and immediate transmissions.
3 Print error code on error report
0: No 1: Yes
1: Error codes are printed on the error reports.
4
Listing of Confidential IDs on
the Personal Code List
0: Disabled 1: Enabled
1: Confidential IDs registered with Personal
Codes by the users will appear on the Personal
Code List.
5
Power failure report
0: Disabled 1: Enabled
1: A power failure report automatically prints
after the power is switched on if a fax message
disappears from memory when the power was
turned off last.