Ricoh FAX2000L - Page 85

BIT SWITCHES 30 November, 1999
4-18
System Switch 09
No FUNCTION COMMENTS
6 Conditions for printing the
protocol dump list
0: Print for all communications
1: Print only when there is a
communication error
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a
protocol dump list only for communications with
errors.
7 Priority given to various types
of remote terminal ID when
printing reports
0: RTI > CSI > Dial label >
Tel. Number
1: Dial label > Tel. number >
RTI > CSI
This bit determines which set of priorities the
machine uses when listing remote terminal
names on reports.
Dial Label: The name stored with the
Quick/Speed Dial number by the user.
System Switch 0A
No FUNCTION COMMENTS
0-3
Not used Do not change these settings.
4
Dialing on the ten-key pad
when the handset is off-hook
0: Disabled 1: Enabled
1: The user can dial on the ten-key pad when
the handset is off-hook.
5
On-hook dial
0: Disabled 1: Enabled
0: On-hook dial is disabled.
6-7
Not used Do not change these settings.
System Switch 0B
No FUNCTION COMMENTS
0
1
Automatic reset timer
Bit 1 Bit 0 Timer setting
0 0 1 minute
0 1 3 minutes
1 0 5 minutes
1 1 No limit
(1, 1): Automatic reset is disabled.
(Other): The machine returns to standby mode
when the timer expires after the last operation.
2
3
Power Saver mode timer
Bit 3 Bit 2 Time Limit
0 0 1 minute
0 1 3 minutes
1 0 5 minutes
1 1 No limit
(1, 1): Automatic Power Saver mode is
disabled.
(Other): The machine goes into Power Saver
mode when the timer expires after the last
operation.
Cross-reference
Power Saver modes: Section 2.3.1
4-7
Not used Do not change these settings.