Ricoh FT 4015 - Page 109

Mode No. Function Settings
59
Optics
Temperature
Display
✝
Displays the optics temperature detected by the
optics thermistor.
Press the

key to monitor the temperature
during the normal copy cycle.
60
Drum Potential
Measurement
(With Paper)
Factory use only.
61
Drum Potential
Measurement
(Without
Paper)
Factory use only.
62
V
L
Correction
Interval
Sets the interval for V
L
correction. The exposure
lamp voltage (SP48) is increased by 1 step at the
set copy count interval.
1 step of the lamp voltage equals 0.5 V for
N-American, and 1.0 V for European machines.
0 ~ 8
Default = 2
See "Detailed Section Descriptions - Exposure
Lamp Voltage Control" for details.
63
Forced Toner
Supply
Forces the toner bottle to supply toner to the
development unit.
0: 6 seconds
1: 3 seconds
This mode starts when the

key is pressed,
and stops automatically after the selected time.
Use this mode to achieve standard image
density when copy quality problems indicate
low toner.
64
V
R
Correction
Value
Sets the V
R
correction value.
Keep this at the default setting.
Default = 0
66
TD Sensor
Initial Setting
Performs the TD sensor initial setting.
This SP mode controls the voltage applied to the TD
sensor to make the TD sensor output 1.9
±
0.1 V.
After using SP66, check SP67 to see if the sensor is
working correctly.
This mode is started by pressing the

key
and stops automatically after about 1 minute.
Use this mode only after installing new
developer.
67
TD Sensor
Initial Output
Display
Display the TD sensor initial setting output.
(0.02 V x
displayed
value)
SP Setting Exposure Lamp Note
0 +2 steps/8,000 copies
1 +2 steps/6,000 copies
2 +2 steps/4,000 copies Default
3 +2 steps/2,000 copies
4 +2 steps/1,000 copies
5 No Correction
Service
Tables
20 December 1996 PROGRAM MODES
4-19