1.16 PAPER MISFEED
- Problem -
1. The Check Paper Path indicator turns on when the main switch is turned
on, even if there is no paper in the copier.
2. The Check Paper Path always turns on at the same location when copies
are made.
- Possible Causes -
1. Defective sensor
2. Mechanical or electrical malfunction
- Action 1 (Initial misfeed) -
Check which sensor (registration sensor or exit sensor) is defective.
Replace the defective sensor. If no sensors are defective,
replace the main board.
- Action 2 (Misfeed during copy cycle) -
If the Check Paper Path indicator turns on after the
key is pressed,
check whether the paper tray has run out of paper or not.
No Yes
Load paper into the paper tray
Enter Misfeed Detection OFF mode (SP6) and make a copy to see whether
a misfeed occurs.
Misfeed No misfeed
Check which sensor (registration sensor or exit sensor)
is defective. If sensors are not defective, replace the main board.
Check whether a mechanical or electrical malfunction occurs. Replace the
defective parts.
COPY QUALITY 20 December 1996
7-20
To Next Page
Loading...
