4. To retrieve the programmed set-
tings, press the Program key be-
fore copying.
2–Changing The Copier’s Default Settings
You might find that you never use the copier’s default settings, that you
always set a lead margin of 10 or 20 mm, or that you always use the roll
feeder with a particular length of paper.
In this case, you might want to change the settings that appear when
you turn on the copier or press the Clear Modes key . To do so, fol-
low the steps below.
1. Turn the main switch off.
2. Press
and hold
the Emergency
Stop key, then turn the copier
back on. The jam and service in-
dicators blink.
C/
Programming Settings You Often Use COPYING
15
To Next Page
Loading...
