Ricoh FW770 - Page 214

4
11. {
{{
{Function Select}
}}
} key
Press to change which setting you are ed-
iting. The current selection is shown by
the indicators above the key:
•Paper Length
•Leading Edge
•Copy Counter
Also used for copying a selected portion
of the original.
12. {
{{
{+}
}}
} and {
{{
{—}
}}
} key
Press to increase the value being edited.
Press to decrease the value being edited.
13.
Leading Edge/Copy Counter in-
dicator
Displays the margin settings and the
number of copies made.
14. Roll Feeder indicator
Light up when you select Roll Feeder 1 or
2.
15. {
{{
{RF Select/Cut}
}}
} key
Use to select the paper feed type (when
the Roll Feeder option is installed). Also
press to stop a copy job.
16. {
{{
{Copy Media}
}}
} key
Press to select the type of copy paper you
are using.
The copier will apply more or less heat
accordingly.
• The top indicator-Translucent paper
indicator
• The bottom indicator-Film indicator
17. {
{{
{Emergency Stop}
}}
} key
Press to stop the copying process imme-
diately.
Use if your original is getting stuck in the
copier.
If you stop operation by pressing this
key, remove both the original and paper.
18. Density indicator and {
{{
{i
ii
i}
}}
},
{j
jj
j}
}}
}keys
Shows the density level the copies will
have.
Press the left key to make copies lighter.
Press the right key to make copies darker.
19. {
{{
{Paper Feed}
}}
}key
Press to feed the paper.
Paper Feed indicator(LED) lights up
when the machine is ready to feed roll
paper.
20. {
{{
{Clear/Stop}
}}
} key
When entering numbers, press to cancel.
While copying, press to stop copying.