Ricoh G-P3 - Page 151

1001 047 Tray4:Normal:RS *EGB [-10.0 to 10.0 / -3.0 / 0.1 mm/step]
1001 048 Tray4:Thick *EGB [-10.0 to 10.0 / 1.5 / 0.1 mm/step]
1001 049 Tray4:OHP *EGB [-10.0 to 10.0 / 0.0 / 0.1 mm/step]
1001 050 Tray4:Normal2:LS *EGB [-10.0 to 10.0 / 1.0 / 0.1 mm/step]
1001 051 Tray4:Normal2:RS *EGB [-10.0 to 10.0 / 1.0 / 0.1 mm/step]
1001 052 Tray4:Thick2 *EGB [-10.0 to 10.0 / 1.5 / 0.1 mm/step]
1001 053 Tray4:Thin:LS *EGB [-10.0 to 10.0 / 0.0 / 0.1 mm/step]
1001 054 Tray4:Thin:RS *EGB [-10.0 to 10.0 / 0.0 / 0.1 mm/step]
1001 055 Tray4:Special *EGB [-10.0 to 10.0 / 1.5 / 0.1 mm/step]
1002 [S-to-S Reg.] Side-to-Side Registration
1002 001 By-pass *EGB
Adjusts the side-to-side registration for each
mode. This SP changes the laser main scan start
position.
[-10.0 to 10.0 / 0.0 / 0.1 mm/step]
1002 002 Tray 1 *EGB
1002 003 Tray 2 *EGB
1002 004 Tray 3 *EGB
1002 005 Duplex *EGB
1002 006 Tray4 *EGB
1003
[Paper Buckle] Paper Buckle
(Tray or By-pass, Paper Type, Process Speed)
Paper Type ->N: Plain paper 1, N2 or Normal 2: Plain paper 2, Thick2: Thick paper 2
(see the Specifications table for details on these paper weights)
Process Speed-> LS: Low speed, RS: Regular speed
1003 001 Tray 1: Normal: LS *EGB
Adjusts the amount of paper buckle at the
registration roller for each mode. This SP
changes the paper feed timing.
[-10.0 to 10.0 / 0.0 / 0.1 mm/step]
1003 002 Tray 1: Normal: RS *EGB
1003 003 Tray 1: Thick *EGB
1003 004 Tray 1: OHP *EGB
1003 005 Tray 2: Normal: LS *EGB
5. Service Tables
150
5