ENGINE SERVICE MODE
G104 5-62 SM
5816 010 RCG Read Timeout *CTL
Sets the timeout counter for reading
processing.
[0 to 100 / 60 / 1 second/step]
5816 011 Port 80 Enable *CTL
Enables or disables access to the SOAP
method via port 80.
[0 to 1 / 0 / 1/step]
0: Disables, 1: Enables
5821 [Remote Service Address]
5821 001 CSS-PI Device Co *CTL [0 to 4 / 0 / 1/step] DFU
5821 002 RCG IP Address *CTL
Sets the IP address of the RCG (Remote
Communication Gate).
[00000000h to FFFFFFFFh / 00000000h /
1/step]
5824 [NV-RAM Data Upload]
5824 001 #
Uploads the UP and SP mode data (except
for counters and the serial number) from the
NVRAM to an SD card.
5825 [NV-RAM Data Download]
5825 001 #
Downloads the UP and SP mode data from
an SD card to the NVRAM.
5828 [Network] Job spool settings/ Interface selection for Ethernet and wireless LAN
5828 050 1284 Compatible *CTL
Switches Centronics IEEE1284 compatibility
on/off for the network.
[ 0 or 1 / 1 / - ]
0: Disabled, 1: Enabled
NOTE: Selecting “0” disables bi-directional
data transmission.
5828 052 ECP *CTL
Switches the ECP setting for Centronics
off/on.
[0 or 1 / 1 / -]
0: Disabled, 1: Enabled
NOTE: With “1” selected, SP5-828-050
must be enabled for 1284 mode
compatibility.
5828 065 Job Spool *CTL Switches the job spool on/off.
[0 or 1 / 0 / -]
0: Disabled, 1: Enabled
5828 066 HD job Clear *CTL
Selects the treatment of the job when a
spooled job exists at power on.
[0 to 1 / 1 / 1/step]
0: Data is cleared, 1: Automatically printed
To Next Page
Loading...
