ENGINE SERVICE MODE
SM 5-63 G104
Service
Tables
5828 069 Job Spool (Protocol) *CTL
Switches job spooling off or on and enables
settings for job spooling protocols.
[0 to 1 / 1 / 1/step]
0: Off, 1: On
Bit switch:
• Bit 0: LPR
• Bit 1: FPT
• Bit 2: IPP
• Bit 3: SMB
• Bit 4: BMLinkS
• Bit 5: DIPRINT
• Bits 6 and 7: Reserved
5828 084 Print Settings List - Prints a list of NCS related parameters.
5828 085 IP Interface - displays the IP interface.
[0 to 3 / -]
0: No IP device, 1: DHCP
2: Static IP address
3: DHCP and Static IP address
5828 090 TELNET *CTL Enables or disables Telnet.
[0 to 1 / 1 / 1/step]
0: Disabled, 1: Enabled
5828 091 Web *CTL Enables or disables the Web monitor.
[0 to 1 / 1 / 1/step]
0: Disabled, 1: Enabled
5832 [HDD Init.] HDD Initialization
5832 001 #
Prepares the hard disk. Use this SP mode
only when there is a hard disk error.
5839 [IEEE 1394]
5839 004 Host Name *CTL Displays the host name.
5839 007 Cycle Master *CTL [0 or 1 / 1 /-] Alphanumeric
0: Off, 1: On
5839 008 BCR mode *CTL [0 to 3 / 3 / 1/step] Alphanumeric
0: Standard, 1: IRM Color Copy
2: Reserved, 3: Always Effective
5839 009 IRM 1394a Check *CTL [0 or 1 / 0 /-]
0: Off, 1: On
5839 010 Unique ID *CTL [0 or 1 / 1 /-]
0: Off, 1: On
5839 011 Logout *CTL [0 or 1 / 1 /-]
0: Off, 1: On
5839 012 Login *CTL [0 or 1 / 0 /-]
0: Off, 1: On
5839 013 Login MAX *CTL [0 to 63 / 8 / 1/step]]
To Next Page
Loading...
