ENGINE SERVICE MODE
G104 5-64 SM
5840 [IEEE 802.11b]
5840 006 Channel Max *CTL
Sets the maximum number of channels
available for data transmission via the
wireless LAN. The number of channels
available varies according to location. The
default settings are set for the maximum end
of the range for each area. Adjust the upper
4 bits to set the maximum number of
channels.
EU: [1 to 13 / 13 / 1/step]
NA/ AS: [1 to 11 / 11 / 1/step]
5840 007 Channel Min *CTL
Sets the minimum number of channels
available for data transmission via the
wireless LAN. The number of channels
available varies according to location. The
default settings are set for the minimum end
of the range for each area. Adjust the lower 4
bits to set the minimum number of channels.
EU: [1 to 13 / 1 / 1/step]
NA/ AS: [1 to 11 / 1 / 1/step]
5840 011 WEP key number *CTL Selects the WEP key.
[00 to 11 / 00 / 1 binary]
00: Key #1
01: Key #2 (Reserved)
10: Key #3 (Reserved)
11: Key #4 (Reserved)
5842 [NFA analisis] Net File Application Analysis
5842 001 *CTL
Prints or does not print the module log for
each bit.
[0 to 1 / 1 / 1/step]
0: Prints, 1: Not print
Bit switch:
• Bit 0: System or other related application.
• Bit 1: Captured related application
• Bit 2: Certification related application
• Bit 3: Address related application
• Bit 4: Control devices or transmission logs
related application
• Bit 5: Output (print, fax or transmission)
related application
• Bit 6: Documents related application
In the Bit 7, 0: Not print, 1: Print
• Bit 7: MSB related application
To Next Page
Loading...
