Ricoh G104 - Page 182

ENGINE SERVICE MODE
G104 5-66 SM
5857 009 HDD to SD (4MB) *CTL
Copies the most recent 4 MB of the debug
log from the hard disk to the SD card.
5857 010 HDD to SD (Any) *CTL
Sets the key number of the debug log copied
from the hard disk to the SD card.
5857 011 Erase HDD Log *CTL Deletes the debug log from the hard disk.
5857 012 Erase SD Log *CTL Deletes the debug log from the SD card.
5857 013 Free Space on SD *CTL Shows the free space on the SD card.
5857 014 SD to SD (4MB) *CTL
Copies the most recent 4 MB of the debug
log from an SD card to a different SD card.
5857 015 SD to SD (Any) *CTL
Sets the key number of the debug log copied
from an SD card to a different SD card.
5857 016 Make HDD Log File *CTL
5857 017 Make SD Log File *CTL
Makes a log file on the HDD to save debug
logs. To save debug logs, the controller
makes a log file first, then writes data in the
file. This procedure can use much time. The
user can switch off the main power switch
before the log is written in the file. To prevent
this possible problem, you can prepare a log
file in advance. If you do this, the controller
uses less time to save logs because the log
file is prepared.
5858 [Debug Save When]
5858 001 Engine SC Error
*CTL
Collects debug logs when an engine-related
SC code occurs.
[0 to 1 / 0 / 1/step]
0: OFF, 1: ON
5858 002 System SC Error
*CTL
Collects debug logs when a controller-related
SC code occurs.
[0 to 1 / 0 / 1/step]
0: OFF, 1: ON
5858 003 Any SC Error
*CTL
Sets the SC code whose logs are collected.
[00000 to 65535 / 0 / 1/step]
5858 004 Jam
*CTL
Collects debug logs when a paper jam
occurs.
[0 to 1 / 0 / 1/step]
0: OFF, 1: ON
5859 [Log Save Key No.]
5859 001 Key 1
*CTL
5859 002 Key 2
*CTL
5859 003 Key 3
*CTL
5859 004 Key 4
*CTL
5859 005 Key 5
*CTL
5859 006 Key 6
*CTL
5859 007 Key 7
*CTL
5859 008 Key 8
*CTL
5859 009 Key 9
*CTL
5859 010 Key 10
*CTL
Sets the key number of a specific event (
NOTE) whose logs are saved in the specified
storage ( NOTE). When multiple key
numbers are assigned, the logs are collected
in this order: Key 1, Key 2, ..., Key 9, Key 10.
NOTE: The event is set with SP5-857-2. The
storage is set with SP5-858.
[0000000 to 9999999 / 0 / 1/step]
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA