SERVICE PROGRAM MODE
SM 5-29 G108
Service
Tables
8061*
T: FIN Jobs
8064*
P: FIN Jobs
8067*
O: FIN Jobs
The number of times the application program uses the
finisher
[0~9999999/ 0 / 1/step]
001 Sort The number of times the application program starts the sort
mode
002 Stack The number of times the application program starts the tack
mode
003 Staple The number of times the application program starts the staple
mode
004 Booklet The number of times the application program starts the
booklet mode
NOTE: The counter of the staple mode (003) can also
increase.
005 Z-Fold The number of times the application program starts the Z-fold
mode
NOTE: The booklet mode is not included.
006 Punch The number of times the application program starts the
punch mode
NOTE: The counter of the printer application program (P:)
can also increase.
007 Other (Reserved)
8071*
T: Jobs/PGS
8074*
P: Jobs/PGS
8077*
O: Jobs/PGS
The number of jobs that try to output a specific number of
pages
[0~9999999/ 0 / 1/step]
001 1 Page 008 21~50 Pages
002 2 Pages 009 51~100 Pages
003 3 Pages 010 101~300 Pages
004 4 Pages 011 301~500 Pages
005 5 Pages 012 501~700 Pages
006 6~10 Pages 013 701~1000 Pages
007 11~20 Pages 014 1001~ Pages
• The jobs interrupted by paper jams or other errors are also counted.
• If a job is suspended and restarted later, the job is seen as one job.
• If the finisher runs out of staples during stapling, the job is counted at the time
the error occurs. (Not applicable to this product.)
• The first test print and subsequent test prints to adjust settings are added to the
number of pages of the copy job (SP8-072).
To Next Page
Loading...
