Image Creation
G133 3-30 SM
3. All PCUs ( "p.3-3 "PCU"")
4. Put a sheet of paper (A3/DLT) inside the machine as shown and on the floor.
The sheet of paper on the floor is used in a later step.
5. Release the harness [A] from the clamp (= x 1 for YCM, = x 3 for K) and hook, and
then disconnect the harness.
Avoid touching these spring terminals [B].
6. Release the toner supply tube [C].
7. Remove the toner pump unit [D] ( x 2)
To Next Page
Loading...
