Ricoh G133 - Development Clutches for M and C

Drive Unit
G133 3-66 SM
6. Remove the pulley and bushing [B].
7. Turn the development clutch unit [C] counter-clockwise and then pull it out ( x 1).
8. Development clutch-Y [D] ( x 1)
3.9.16 DEVELOPMENT CLUTCHES FOR M AND C
1. Rear cover ( "p.3-3 "Rear Cover"")
2. PSU bracket ( "p.3-3 "PSU"")
3. Open the controller box. ( "p.3-3 "Controller Box"").
4. Drum/development motors for M and C ( "p.3-3")
5. Disconnect the connector for each development clutch ( x 1).
6. Turn the development clutch unit [A] counter-clockwise and then pull it out ( x 1).
7. Development clutches for M and C [B] ( x 1)