Ricoh G133 - By-Pass Bottom Tray; When Reinstalling this Switch

Paper Feed
SM 3-93 G133
Replacement
Adjustment
1. Open the by-pass tray [A].
2. Move the side fences to the center.
3. By-pass tray cover [B] ( x 4)
4. By-pass paper size sensor [C] ( x 1)
When reinstalling this switch
1. Adjust the projection [E] of the left side fence bar (it must be centered).
2. Install the by-pass paper size detection switch so that the hole [D] in this switch faces
the projection [E] of the left side fence bar.
3. Reassemble the printer.
4. Plug in and turn on the main power switch.
5. Check this switch operation with SP5803-071 (By-pass paper size < Input Check).
- Display on the LCD -
Paper Size Display Paper Size Display
11 x 17 SEF 00001110 5.5 x 8.5 SEF 00001011
8.5 x 14 SEF 00001100 5 x 7 SEF 00000011
8.5 x 11 SEF 00001101 4 x 6 SEF 00000111
7 x 10 SEF 00001001
Smaller than
4 x 6 SEF
00001111
3.11.7 BY-PASS BOTTOM TRAY
1. Open the right door.
2. By-pass tray cover ( "p.3-92 "By-pass Paper Size Sensor Switch"")