Service Mode Table
G133 5-40 SM
005 Lead Edge Width: Thin *ENG
[0 to 9.9 / 5 / 0.1 mm/step]
006 Duplex Trail. L Size *ENG
[0 to 4 / 1 / 0.1 mm/step]
007 Duplex Trail. M Size *ENG
[0 to 4 / 0.8 / 0.1 mm/step]
008 Duplex Trail. S Size *ENG
[0 to 4 / 0.6 / 0.1 mm/step]
009 Duplex Left Width *ENG
010 Duplex Right Width *ENG
[0 to 1.5 / 0.3 / 0.1 mm/step]
2105 [LD Power Adj.] (Process Speed, Color)
Adjusts the LD power of each color for each process speed.
Each LD power setting is decided by process control.
High Speed: 205 mm/sec, Middle Speed: 111 mm/sec, Low Speed: 77 mm/sec
001 High Speed: Bk *ENG
002 High Speed: M *ENG
003 High Speed: C *ENG
004 High Speed: Y *ENG
005 Middle Speed: Bk *ENG
006 Middle Speed: M *ENG
007 Middle Speed: C *ENG
008 Middle Speed: Y *ENG
009 Low Speed: Bk *ENG
010 Low Speed: M *ENG
011 Low Speed: C *ENG
012 Low Speed: Y *ENG
[50 to 120 / 100 / 1%/step]
Decreasing a value makes lines thinner
on the output.
Increasing a value makes lines thicker
on the output.
2106 [Polygon Rotation Time]
To Next Page
Loading...
