Service Mode Table
SM 5-161 G133
Service
Tables
Specifies the maximum number of repeats of the toner density adjustment at job
end.
0: Disabled, 1 to 3: Repeat number,
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low,
and toner is consumed only when the toner density is too dark.)
6 to 9: Disabled
Repeat: Interrupt *ENG
[0 to 9 / 0 / 1 time/step]
007
Specifies the maximum number of repeats of the toner density adjustment
during printing. DFU
Toner Supply Coefficient *ENG
[0 to 25.5 / 10 / 0.1 sec/step]
008
Adjusts the time for the toner supply mode when a toner density is detected to
be low.
K: Toner Consumption *ENG
[0 to 255 / 5 / 1 time/step]
009
Specifies the belt mark generating time for checking the black toner density
when toner density is detected to be low at the toner density adjustment.
M: Toner Consumption *ENG
[0 to 255 / 5 / 1 time/step]
010
Specifies the belt mark generating time for checking the magenta toner density
when toner density is detected to be low at the toner density adjustment.
C: Toner Consumption *ENG
[0 to 255 / 5 / 1 time/step]
011
Specifies the belt mark generating time for checking the cyan toner density
when toner density is detected to be low at the toner density adjustment.
Y: Toner Consumption *ENG
[0 to 255 / 5 / 1 time/step]
012
Specifies the belt mark generating time for checking the yellow toner density
when toner density is detected to be low at the toner density adjustment.
T1 Bias: Bk *ENG
[0 to 80 / 30 / 1 µA/step]
013
Adjusts the image transfer belt bias for Black.
014 T1 Bias: M *ENG
[0 to 80 / 30/ 1 µA/step]
To Next Page
Loading...
