Service Mode Table
G133 5-188 SM
021 Pattern Generation Number: Y *ENG
022
Pattern Generation Number:
Upper limit
*ENG
[0 to 255 / 0 / 1 time/step]
023 Toner Consumption Pattern Area *ENG
[10 to 2550 / 320 / 10 cm
2
/step]
024 Supply Coefficient *ENG
[0 to 2.55 / 1 / 0.01/step]
025 Job End Area Coefficient *ENG
[0.1 to 25.5 / 1 / 0.1/step]
026 Job End Vb Coefficient *ENG
[0 to 100 / 40 / 1%/step]
027 Job End Length *ENG
[0 to 56 / 25 / 1mm/step]
028 Job End Supply *ENG
[0 to 1 / 0.45 / 0.001
mg/cm
2
/step]
[Blade damage prevention mode]
3517
Adjusts the threshold temperature for preventing the cleaning blade at the
drum unit from being damaged. If the temperature is above this value, the
drum reverses briefly at the end of the job to prevent the blade from flipping
over.
001
Execution Temp.
Threshold
*ENG
[0 to 50/ 40 / 1°C/step]
3518 [Image Quality Adj. Execution Flag] DFU
001 Toner End Recovery: Bk *ENG
002 Toner End Recovery: M *ENG
003 Toner End Recovery: C *ENG
004 Toner End Recovery: Y *ENG
[0 or 1 / 0 / 1/step]
0: OFF. 1: ON
005 Vsg Adj. *ENG
[0 or 1 / 0 / 1/step]
0: OFF. 1: ON
To Next Page
Loading...
